Camden Leaseholders’ Forum homepage › Discussion Board › General/Other Issues › Disconnect from communal heating and hot water
- This topic has 4 replies, 4 voices, and was last updated 1 year, 1 month ago by Caroline Knight.
-
AuthorPosts
-
27th September 2025 at 17:11 #7624
Our heating and hot water is supplied by a pipe from the boiler in the neighbouring estate. Can we disconnect from this and install our own heating and hot water. This would avoid the huge heating and hot water bills we get and give us greater control.
Any suggestions how to go about this? Who to ask?
Thanks28th September 2025 at 08:14 #7625I very much doubt you’d be able to do this. I asked to disconnect when Camden were planning to overhaul the communal heating and HW system at Millman St/Place a few years ago and proposed to replace boilers,radiators etc at vast expense – my estimated bill would have been 23K for a 3 bed flat. In fact I asked if all residents could have individual combi-boilers but Camden refused on grounds that not all residents’ flats were configured in a way that would allow for the external venting of a combi-boiler, also that individual boilers would contravene their net zero targets and lead to increased fuel poverty for tenants who might not be able to afford to heat their homes. In the end Camden backed down on the radical overhaul of the system and did a more modest refurbishment which was still at significant cost to me – over 3K.
I recall that some leaseholders on a Highgate Estate were able to disconnect when their communal heating system was overhauled. In any case,Camden should be thinking about more environmentally friendly options for the provision of heating/HW. Even if they’re not, I doubt they’d consider allowing you to install your own boiler, maybe an individual heat pump but that’s unlikely to be suitable for a dense urban environment. Maybe worth asking the leaseholder dept for a contact in ‘Major Works’ or looking for head of Major Works on Camden website.28th September 2025 at 10:07 #7626Thanks. Will update if anything comes out of this.
28th September 2025 at 10:47 #7627We are going through a similar heating “upgrade” as our estate is on a communal system – originally we were told the leaseholders could opt out in terms of heating inside out flats but that we must be able to fit our preferred scheme to the HIUs that are being installed – which will be powered by the gas boilers – but this in no longer an option – reasonable from the point of view that Camden wants to stabilise whats attached to the HIUs in case all the different equipment skews readings and settings. However we are still being powered by Gas boilers and like you would prefer a much greener option. We also have other estates and buildings that share our communal boilers. The works will be eye-wateringly expensive for leaseholders.
28th September 2025 at 21:35 #7628I feel for you!
We had new communal boilers and pipes installed throughout our estate and block and a total of 1 large, 1 medium and 1 small radiator installed in our flat and a Heat Interface Unit.
We had to contribute just over £12,000 for this and now regularly don’t have hot water or the shower goes cold for 30 seconds or so multiple times per shower.
The first year after this the council didn’t track each flats usage and we were charged nearly £3000 for a year’s gas in a 2 person flat. We don’t often turn on the heating but our neighbour a few doors along told me they like to keep theirs at 27 degrees.
It’s very frustrating!
Good luck to you! -
AuthorPosts
- You must be logged in to reply to this topic.